[EMAIL PROTECTED] wrote:
result, I received an error message -- E 00039 ERR VC4 -- and in
consulting the revised manual (version D1) found only references to
having the second receiver installed and to try NOT INST as a means of
correcting this.
Are you really sure that the synthesizer and XCO are installed correctly?
In Manuals B1, C1 and D1 it says:
===============================================================
VCO calibration error. VFO A will show error
data, e.g. E 00039; report this value to
Elecraft customer support.
---------------------------------------------------------------
Verify that the oscillator can on the
KREF3 is fully plugged in and is not in
backwards. Make sure all internal cables
are plugged in, specifically the cables
between the KREF3 and KSYN3 modules
(synthesizers).
...... etc etc etc ......
===============================================================
vy 73 de toby
Thanks, Toby, but the K3 has been operating since March just fine and it
even took a trip to Gary Surrency for an unrelated problem. However,
the latest is that the error disappeared and now I find that the tx RF
meter doesn't work although is puts out nominal power.
Yikes, I'm a bit confused...
73,
Joe, W2RBA
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
