My apologies Bill. The soldered jumper was where I said it was on the Rev XD (preproduction) board that I have.
Wayne said he was moving it to a plug-in wire jumper because it was too hard to get to it with the KIO3 board in place, so I never considered the possibility that it had been moved on the Rev A boards since none of the field testers apparently had those boards (or noticed the error). As you can see in the manual, it's gone entirely from the Rev B board used in the illustration there. I'll make an errata note for the manual to avoid anyone else becoming confused by the note that it's on the other side of connector J64A. Thank you very much for following up with the photo and clearing up the issue! Comments and corrections like yours are the biggest reason I monitor the reflector. Ron AC7AC -----Original Message----- From: Bill NY9H [mailto:[EMAIL PROTECTED] Sent: Monday, August 25, 2008 9:27 AM To: Ron D'Eau Claire; [email protected] Subject: RE: [Elecraft] KRX3 Issue - Jumper W4.... rtfm nope,,,,, the jumper it is NOT between , as described in the manual .... I sent this note to support :on July 16th,,, the w4 jumper is NOT between the w4 jumper block and the Kio boards,,,,, I kept looking to make certain i was looking at the w4 jumper....(which I was) and you do need to take out the general coverage board to get access to clip it ( w4) cleanly... it went right into # 44 bill -------- And since it was contradictory to the instructions in the manual i rechecked it a zillion times ... checked the schemo... then cut w4 For Ron I have attached a pix, which will get stripped by the reflector for the crowd. While there is a jumper located as described , W4 is just in front of the connector. bill _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
