Drew wrote... Some people pre-sort all the screws. I just dumped them and the washers into a shallow pan and hunted through them as they were called out. But do pay close attention to the screw lengths and washer types specified in the instructions.
Very good point. This is especially true when attaching the clear bezel over the LCD. Use the wrong length screw and you will likely damage the LCD. Just take your time and you will do fine. ------------------------- 73, Greg - AB7R Whidbey Island WA NA-065 On Tue Aug 26 14:13 , [EMAIL PROTECTED] sent: >On Tue, 26 Aug 2008 13:09:04 -0700 (PDT), Joe W!JGS wrote: > >> >> - Are there any tools, over and above those mentioned in the assembly >>manual, that would be helpful >> > >Yes, a magnetized screwdriver is very handy for guiding the screws to >their holes without having to fumble with them. (There are a LOT of >screws!) > >Some people pre-sort all the screws. I just dumped them and the >washers into a shallow pan and hunted through them as they were called >out. But do pay close attention to the screw lengths and washer types >specified in the instructions. > >73, >Drew >AF2Z > >_______________________________________________ >Elecraft mailing list >Post to: [email protected] >You must be a subscriber to post to the list. >Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > >Help: http://mailman.qth.net/subscribers.htm >Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
