No video here, but there are pictures in the both the K3 assembly and KRX3 Option manuals (available on the Elecraft web site).
Because there are a LOT of pins in four sockets connecting the front panel assembly to the rest of the K3, it takes some pressure, but nothing spectacular. You could grab the bottom edge of the front panel and pull while holding the main K3 assembly, but there's a big danger that you'll send one half skidding across the table or dropping one section. Either situation is a very bad thing! By using a screwdriver as shown in the manuals, the panel assembly slides easily off under your complete control. Notice that the nominal force is not enough to cause any damage to the edge of the circuit board used for leverage. Just be sure you have all the screws listed removed first so only the connectors are holding the front panel assembly from quite literally falling off. Ron AC7AC -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of alsopb Sent: Wednesday, August 27, 2008 10:25 AM To: [email protected] Subject: [Elecraft] Sub-rx install video/pix? Has anyone created either? It would be interesting to me to see somebody prying off the front panel assembly in video form. de Brian/K3KO -- _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
