My experience is that although it only takes a minute or so to remove the KRX3, it takes quite a lot of time to re-install. Most of that time being taken up in routing the coax cables.
73 Stewart G3RXQ On Thu, 28 Aug 2008 07:27:40 -0700 (PDT), Barry N1EU wrote: > > > Terry Schieler wrote: > >> Will there need to be a substantial amount of disassembly >> of the K3 to get the DVR installed? If this is the case, I will probably >> hold off on installing my KRX3 until the DVR unit arrives and do it all in >> one operation. >> > Terry, the DVR installation is a moot point as far as whether you should > delay KRX3 installation. Once installed, KRX3 removal is quite simple and > can be accomplished in about one minute. You should go ahead and install > your KRX3. > > 73, > Barry N1EU _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
