Awesome, glad to hear it is up and running.
David Wilburn
K4DGW
www.k4dgw.com
Christopher Kovacs wrote:
Looks like it was my mistake.... I could have swore that the DSP was
being loaded the first time. I went back to the previous firmware and
then reloaded the latest beta firmware making sure that I send "all".
It's good now.
Chris w0anm
David Wilburn wrote:
Same firmware here.
Set pitch to 630
Width to .80
Varied shift from lowest setting to highest without issues.
There were two loads that needed to be added for this firmware. Did
you add the DSP as well as the MCU?
David Wilburn
K4DGW
www.k4dgw.com
www.k4rc.net
Williamsburg Area Amateur Radio Club (K4RC)
My Current LOTW/DXCC/WAS status
www.k4dgw.com/WAS.DXCC.info.html
Christopher Kovacs wrote:
Hi all,
I just upgraded to the latest beta. Set pitch to 630 and then varied
the "WIDTH" and SHIFT". Set the WIDTH for 0.80 then when shifting
passed FC 0.35, the receiver dies with an error "E 00000C" ERR DSE.
It doesn't appear to matter what the "pitch" tone is set. After the
error occurs, you must change the SHIFT setting > 0.35 and power off
and on.
Chris W0ANM
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft Help:
http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: Elecraft@mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
