> -----Original Message----- > From: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED] On Behalf Of Nelson > Wittstock > > I just installed my new KRX3 and I do not have any audio. > There is no hissing sound as there is when I use the main > receiver. In the Config menu I have set ANT=BNC as I > installed the TMP cable with the BNC connector to allow me to > do diversity work later. In BSET I have the ANT set to MAIN. > When I tap the SUB button the SUB icon on the screen lights > up. SUB RF gain is full clockwise. What setting do I need > to set or correct? Is it possible that it isn't plugged in > correctly? The two long screws that go through the receiver > mated easily with the standoffs below so I don't think it > could be displaced.
This sounds like what happened to me. I was set to CONFIG:SPKRS 2 but I unplugged my stereo speakers during the installation and then began testing using the internal speaker. Make sure you set CONFIG:SPKRS 1 if you are trying to do that. The internal speaker only hears the main RX if you're set for stereo. 73 & HTH Carl WS7L _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
