Hi All,
I received my kit on Friday August 29 and spent this weekend putting it
together (K3/100, KAT3, KBPF3, KFL3A-6k, KFL3A-2.8K, KFL3B-FM, KRX3,
KTCX03-1 and KXV3. Yes, I had to hold off for one week as I could not
block the time to do it. All seemed to go well, everything checked out
along the way and it seems to work, except for a few setup/calibration
issues that I can not figure out.
1) When I try to Calibrate the Reference Oscillator using Method 3, I
can get to the CONFIG:REF CAL, I see 49.380.000 but when I "Tap 1"
nothing happens?
2) High Power (50 W) TX Fain Calibration, it only shows 5.0W as it did
with the (5 W) Calibration?
3) When in VFO IND, it says NO, when I try to change it to YES, it won't
go, and it then shows "UNAVAIL"?
Any advice would be greatly appreciated.
Thanks
Bob
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
