Finally got the KRX3 up and running after Wayne and Gary suggested I look at the 27 ohm resistor I soldered over R91...boy, am I red faced on this one as one leg had a "cold solder" joint on it. Guess didn't let the pad get warm enough to "tack" the leg down on the PC via.
That solved the ER PL1 problem. Now the only thing I am not getting is signal(s) on the right headset. I tried everything so far but must be missing something real simple. CONFIG SPKR+PHONE: NO CONFIG SPKRS: 1 KRX3: ANT=BNC ( I did not install any of the cables (ATU or BNC)) Tried the SUB on, then BSET and antenna selected was MAIN but still nothing from the right headset, just noise ! If this is something real simple, I am going to wear a dunce cap for the remainder of the year ! Tom/k1tl... _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
