I found out why I was not hearing any signals on the KRX3...when I first setup the KRX3 filters, I installed it in slot 1 and then changed it to slot 2. I configured slot 2 but forgot to disable slot 1...duh ! ! !
W1EM suggested I go to the K3 Utility program and see all the filters and that is where I found that FIL1 was still enabled. Since I had both setttings the same, it was looking at slot 1 for the 2.7KHz filter. I think Elecraft should put that in their K3 and KRX3 manual, to use the K3 Utility Program to setup the filters, as it is PAINLESS ! ! ! ! Now I am in the corner wearing the Dunce Cap ! ! Tom/k1tl... _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
