Dave,
You should not have to re-do any alignment after a firmware load.
As part of the Firmware Test Team, I upgrade my firmware almost daily,
sometimes multiple times each day, and I do *not* redo the PLL or any
other alignment.
I would only re-do an alignment if the firmware change directly affected
it, and in that case, the firmware release instructions would state that
it should be done. (It has not happened so far).
73,
Don W3FPR
David Robertson wrote:
Hi there all.
This may have been covered somewhere in the past but I haven't found it.
When you upgrade your firmware in the K3 should you redo your PLL and other
alignments?
Seems logical to do so but my K3 seems to be functioning very well without
redoing the alignments.
Any comments?
Thanks
73 Dave KD1NA
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
