Hi,
I've noticed that my power output on 40 meters LSB is a lot higher than
expected. I get four to five bars or more on the peaks in the ALC mode. I
even got a high current reading last night and I then turned the power back
from 12 watts to 10. I get 4 to five bars even at five watts. It didn't make
much difference and I've found that I need to hold the mic further away. I
switched to USB on 40 meters and it looks fine. It looks good on the higher
USB frequencies also. I've noticed that it is around 2 to three bars on 80
meters LSB which is normal according to the manual.
I'm wondering if it could be a carrier balance adjustment? Any ideas would be
greatly appreciated. Everything else appears normal. I've checked all solder
connections on the SSB board several times and re-flowed the connections I
considered suspect.
Thanks,
Gary, N7HTS
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
