Hi Joe (W4TV), Direct reply to your message does not go through so I send it via the Reflector.
I just checked again on my K3 : if the subreceiver is ON (tap SUB) and I hold BSET, the S-meter shows effectively the strength of the signal of the subreceiver. To change the settings of the subreceiver (e.g. of the filters), I select the appropriate config setting and then I tap SUB before selecting the value of the setting. The Crystal Filter setup method is described in the K3 Owner's manual (page 43 in my C1 version, dated 18 November 2007, or page 45 in the latest edition, D1, dated 27 July). The instructions for BSET can be found either on the second page of the KRX3 errata sheet sent by Elecraft with the KRX3 kit, or on page 37 of the K3 Owner's manual, version D1). Best regards & 73 de Raymond, F4FNT K3/100 # 615, K2/100 #5,636 _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
