Don't attempt to load firmware into your K3 through a microHAM device. Use a USB to Serial Adapter or RS-232 cable that sends exactly what is sent by the K3 Utility.
Some users have sometimes succeeded by changing the microHAM Router to a radio type "none" before loading K3 firmware, but sometimes (depending on the microHAM router version) that doesn't work either. Dick, K6KR -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Eric Sent: Tuesday, September 23, 2008 1:12 PM To: [email protected] Subject: [Elecraft] MCU LD OK, I tried to load new firmware to the K3, not using the USB-serial cable, but thru the micro keyer interface which is normally connected to the K3. At first my PC 'sees' the K3 but during upload something went wrong and now I have a K3 displaying MCU LD and a blinking TX LED. Anyone has a lead here? vy 73 Eric PA3CEV _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
