A funny thing just happened. I went to turn on the K3 for the first time today and when I turned the psu on, the radio sprang to life straight away without having to press the power button.
Than when I press the power button to switch the K3 off I get a bright blank screen and it will not turn on again until I disconnect and reconnect the 12v psu! Other than this behaviour, the K3 appears to function normally. I did have to swap over the dsp boards yesterday but it functioned fine immediately after that, I know it did because I had to update the firmware on the dsp board and I cycled the power normally after doing it. Any ideas? I'm confused. I have disconnected everything from the front and back of the K3 apart from the powerpole and antenna. Thanks and 73 Stephen G4SJP _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
