So when I'm in DATA mode how do I ensure that I am not using any ALC?
A good data mode operator monitors ALC all the time as using ALC can often
result in a wide signal.
Simon Brown, HB9DRV
www.ham-radio-deluxe.com
----- Original Message -----
From: "Don Wilhelm" <[EMAIL PROTECTED]>
"In this case, the ALC meter display is acting as a "VU Meter" and is
being used to help you set the Tx audio path gain correctly. It is not
showing you how much you are over-driving the PA. This is why you can set
it up in Tx test mode, when you are not transmitting any RF at all. "
Additional information can be found in Rev D of the K3 user's manual on
page 32.
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
