Scott, Once you installed the replacement SYN board, did you complete the VCO calibration and then the TX Gain calibration procedures as well as setting the reference oscillator frequency?
------------------------- 73, Greg - AB7R Whidbey Island WA NA-065 On Mon Oct 6 15:47 , [EMAIL PROTECTED] sent: >Hello >When I put my K3/10/kit together it would not receive or >transmit. Working with Gary at Elecraft we decided that the >synthesizer board was bad. They sent me a new one and now >I have receive and the K3 wattmeter shows full output in >cw mode, but my external wattmeter shows very little output. >The needle shows less than the needle width of output. >There is nothing wrong with the external watt meter because >it works fine with my K2. >I am not getting any error messages as I was before changing >the synthesizer board. >Any ideas? >Thanks >Scott N5SM > >_______________________________________________ >Elecraft mailing list >Post to: [email protected] >You must be a subscriber to post to the list. >Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > >Help: http://mailman.qth.net/subscribers.htm >Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
