The step should say black, not zinc. Additional 3/16" screws are supplied with your filters, one per filter.
Ron AC7AC -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Paul Ferguson Sent: Friday, October 10, 2008 11:55 AM To: [email protected] Cc: [EMAIL PROTECTED] Subject: [Elecraft] K3: Error in KRX3 installation instructions? I am in the middle of installing my KRX3 and came to a point where I do not have enough of the correct screws remaining. I am using KRX3 Installation and Operation manual Rev B (Aug 20, 2008) and Errata Rev B-2 (Sep 30, 2008). My inventory matched the manual as modified by the Errata. I might have used the wrong screws somewhere, so I went back thru the steps keeping track of what the steps say I should have used. I came to a problem on page 31, step 2. It calls for two 4-40 3/16" zinc pan head screws. The inventory does not list any of the above screws. There are zinc pan head 4-40, 1/4" and black pan head 4-40 3/16" screws. I do not know if I used zinc 1/4" or black 3/16" during this step. What should this step say? Paul Ferguson _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
