Hi
Anyone else notice this problem.
1. The K3 is placed into the AM mode, the tune button is then pressed for a
normal tune cycle while in the AM mode..
2. Immediately after doing a tune, the transmitter is then keyed in the AM
mode, the power spikes upwards to 60 watts of carrier and stays at 60 watts of
carrier each time you key on AM.
3. Adjusting the power output control makes the K3 reset to a nominal 40 watts
of carrier power and the power output is stable. Initiating another tune cycle
with the tune button will again increase the AM carrier power.
4. If you don't touch the power control the K3 will output 60 watts of
carrier power. If you then just slightly adjust the power output control the
power resets to 40 watts of AM carrier.
All tests were done into a dummy load. I am using the latest Beta Firmware
release. I did not test the AM mode in previous Beta releases.
73
Craig
VK3HE
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
