Ken,
The K2 uses high-side LO injection for the bands 17m and below, but for
15m and above low-side LO injection is used.
What that means is that the K2 'switches sidebands' at 15 meters and above.
That is the reason that the recommended filter/BFO setup is done on one
of the lower bands (40 meters is usually recommended), and the CW
filters are set below the filter center and the CWrev filters are set
higher than the filter center. The same goes for SSB - LSB is below the
filter center while USB is above *except* for the 15, 12 and 10 meter
bands where the sidebands are reversed. The firmware automatically
corrects for the shift, but you can see it in a waterfall display.
If you are using the RTTY filters, they are usually set with the
sidebands like those for CW and SSB, but the normal mode of operation is
with RTTYrev which will be the upper sideband set.
73,
Don W3FPR
Ken Roberson wrote:
Hello All,
My first time to ask fer help.
What sideband sud the cw sidetone be on , Upper
or lower sideband .
And how do i change it.
Some bands are set fer lower and some fer upper.
I am using MixW digi mode software and on the waterfall I can c the change when
i switch
from 20M to 15 M , When the rig is in CW mode.
Tnx 73 Ken K5DNL
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
