Thanks Vic... that was it. Somehow TX INH had been set to LO=INH. I
set it back to OFF, and power suddenly returned. Thanks again for the
wisdom of this group!
Bill
W4ish
On Oct 17, 2008, at 7:37 PM, Vic K2VCO wrote:
William Evans wrote:
Thanks Lyle, but I have already tried that, and the K3 is NOT in
test mode.
Check CONFIG TX INH. If it isn't off and the TX INHIBIT pin is
floating, it might cause the symptom you have.
--
73,
Vic, K2VCO
Fresno CA
http://www.qsl.net/k2vco
"There are 10 types of people in the world -- those who understand
binary and those who don't."
William Evans
[EMAIL PROTECTED]
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
