The K3 doesn't change its baud rate without some front panel action or PC command. The K3 Utility determines the K3's baud rate by trying each of the four supported speeds.
Dick, K6KR -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Jack Colson Sent: Monday, October 20, 2008 2:35 PM To: [email protected] Subject: [Elecraft] Solved: How to communicate with the K3 using N1mm Well it is working, i presumed that the K3 would auto-baud with what ever bit rate it was receiving. Not so, mine was sitting at 9600. Once the two were set to agree, BINGO! Thanks to all - sorry I should have looked at the config -rs232 on the K3 before asking for help. 73 Jack, W3TMZ _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
