Terry,
That is NOT the latest firmware - you want MCU 2.46 / DSP 1.92. I don't
know if that will solve your problem or not, but there release notes
include:
"MCU 2.37 / DSP 1.90, 9-2-2008
* FIRMWARE UPGRADE PROCESS IMPROVEMENT: When upgrading firmware,
MCU and DSP code versions may temporarily become incompatible,
resulting in error messages during loads. These spurious errors are
now suppressed, resulting in a cleaner upgrade process, especially
when upgrading from much older revisions."
http://www.elecraft.com/K3/k3_software.htm
Good luck!
~Iain / K6IAM
On 10/21/08 12:15 PM, g4mkp wrote:
Can you please help?
It never rains……..I have downloaded the latest FW from the server as
follows:
MCU 2.22
FPF 0.02
DSP1 1.88
DSP2 0.188 (don’t have the second rx so this is redundant I think.
Having completed the update to the K3 (Send all new firmware to K3) the
utility informs me that DSP 1 load failed. The rig is displaying the
following error:
E 000C0C
ERR DSE
I understand that this error indicates a failure of DSP 1 which
correlates to the utility message.
Problem now is the utility reports that the K3 is not responding. I have
just gone past the cold sweat stage and I’m off to make a cup of tea.
Cheers,
Terry
G4MKP
------------------------------------------------------------------------
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
