Hi,
I turned on the K3 today and all CW was gone. Pitch had become 000, where I
always use 550. Filter width, LO and HI were giving strange results.
In LSB on 40 meters, if I tap memory M1-M4 the passband of the signals become
smaller but LO/HI, BW and WIDTH do not change. Going to CW and back to LSB the
receiver seems normal again. Because there is no KDVR3 installed, I usually got
the message: NO DVR or N/A when tapping one of the 4 memories. Now
unpredictable things happen.
NORM also sets the receiver back to normal. Does anyone have the same problem?
Reloading the firmware 257 a few times does not correct the problem.
73 's Steef PA2A
K3 1184
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
