Hi Drew:
I sometimes take my K3 for a visit to a neighboring SW band.
When I'm finished SWLing, I just press [A/B] to swap the (still-in-ham-band)
VFO B freq with VFO A and then press [A>B] to reset VFO A back to ham
band as well.
Two buttons, no problems.
73,
Tom N0SS
At 09:35 10/29/2008, you wrote:
On Wed, 29 Oct 2008 10:20:59 -0400, David Wilburn
NM4M wrote:
>Sweet. Thanks Elecraft! You must of been reading my mind. It is
>hard to explain exactly how annoying it was recently having to keep
>stopping on 60m when I was going back and forth between 40m and 80m
>during CQ WW SSB.
>
>David Wilburn
>NM4M
>
The only remaining annoyance is what happens when you leave the ham
bands, say if you leave 30m ham band and go into the 31m SWBC band:
the 31m band gets set as your 30m ham band. But with judicious
programming of the M1 thru M4 buttons you can at least restore it
quickly enough.
73,
Drew
AF2Z
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
