> Here's what's in the command: PC0500;PC;DS;
>
> I tried it again and I get the same thing. The power cannot be
adjusted
> with the front panel dial past 12 watts.
Hi all,
In the 4-digit version of the "PC" (power control) command, the 4th
digit is a range selector: x0.1 or x1 watts. The first three digits set
the desired power level.
For example if you wanted 3.5 watts, you'd send: PC0350
while for 35 watts you'd send: PC0351
In the QRP case, the KPA3 would be put into bypass mode, hence your
inability to go above 12 W with the front panel knob. You could go into
CONFIG:KPA3 and set it back to PA NOR, or just send a PC command with a
'1' at the end.
Note that the 4-digit version of the command is only available if you
turn on K2-style command extensions, by sending "K22". This allows you
to set power in 0.1-watt units, as described above. If you turn K2
extensions off (by sending "K20"), you'll be at the original 3-digit
version of the PC command, which is always in watts, and will not
affect the mode of the KPA3.
For further details please see the K3 Programmer's Reference, on our
web site.
73,
Wayne
N6KR
---
http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
