Randy, it sounds like you have N1MM set up to activate PTT via serial command to the radio. Look in your COM port config page for a checkbox where you can turn off "Radio PTT via command".
GL & 73, Carl, WS7L K3 #486 > -----Original Message----- > I enjoyed last weekend operating SSCW with my new K3/10 and > N1MM. Both were a joy to use!! I have one curiosity > however. I have the K3 setup for semi-QSK with a delay of > 0.03 which works fine for me at about 25 wpm. However, the > keying through N1MM operates as though PTT is enabled at the > beginning of a transmission and disabled at the end. In > other words, I hear no signals during the N1MM transmission. > I'm keying through the RS232 port on the K3 from a standard > serial port on my PC (same cable as used for the CAT from > N1MM). I have PTT--KEY set to OFF-dtr, N1MM set for DTR-CW, > RTS-Always off. Is there something I'm missing? > > 73, > Randy, KS4L > K3 #2006 > K2 #337 _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
