We are not getting any audio from the sub receiver after newly installing the
KRX3. It aligned per the instructions, downloaded all new firmware ok. It set
ANT=BNC. I installed the 2.7 filter in FL3, the .400 in FL4 and the .200 in
FL5, mirroring the way I have the main set up. It ran the calibration
procedures per the manual. However, it will not set config:VFO IND to yes,
saying it is not available.
Any ideas where to look would be appreciated. I guess it is likely one pin is
not seated properly, but the ones I can see seem to be. There are a few that
are not easily visible. All cables seem correctly located.
Thanks in advance.
Fred Serota, K3BHX
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
