You can use the K3 Utility filter configuration tool to verify the filter settings for both main and sub receiver. From the K3 Utility's "Configuration" tab, click "Edit Crystal Filters" and click on the Main / Sub Receiver radio button at the bottom left of the dialog.
The main receiver filter settings are distinct from the sub receiver filter settings. Setting the main receiver's filters does not set the configuration of the sub receiver filters. I loaned my K3 to K7RI to get ready for Sweepstakes or I'd try to describe how to view and set the sub receiver filter configuration from the K3's front panel. I believe it can be done, I just can't verify the procedure. Dick, K6KR From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Roy Morris Sent: Tuesday, November 11, 2008 5:47 PM To: [email protected] Subject: [Elecraft] [K3] Setting Filter Gain in KRX3 I have installed the KFL3A-500 filter in slot #5 in both receivers. When I set main receiver FL5 GN to 6 dB and go to B SET, the gain sounds about the same in the KRX3 as it does in the main receiver. Since the dB setting cannot be seen in B SETdisplay, how do you know the gain settings are the same? When the main receiver filter bandwidth, offset and gain are set in CONFIG, does the corresponding KRX3 filter automatically get set to the same parameters regardless of filter slot used? Maybe all this can be determined in K3 UTILITY. Any comments would be appreciated. Roy Morris W4WFB
_______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
