Jim Brown wrote:
Lots of questions. See some answers interspersed.
On Tue, 11 Nov 2008 18:22:50 -0800, Dick Dievendorff wrote:
I think I usually get that right (along with kHz), but I get confused when I
see dBi, dBm, seemingly dBx for all X. I presume it's a measure of loudness
relative to X, so a dBi is gain relative to an isotropic radiator, and dBw
is what with watts?
All dB is relative -- that is, A is x dB louder or quieter than B.
Unfortunately, on the K3, Elecraft apparently confuse the issue by using
a "v" suffix to indicate that the dB, although not relative to a defined
standard, are computed using the 20 Log 10 (V1/V2) method, rather rather
than the 10 Log 10 (P1/P2) method. (Whilst these are identical if the
load impedance is constant, they produce different results if the
impedance isn't constant.)
And is a dB of voltage equivalent to a dB of power or an audio dB of
loudness?
Audio dB are weighted by frequency, so the same power at different
frequencies will not produce a 0dB difference.
Broadcasters have long been in an eternal search for loudness. If the meter
moves below the red there isn't enough processing, and someone is going to
get fired. :)
It's more complex than that. Classical music broadcasters need to
respect dynamic range, whereas pop music broadcasters tend to want
maximum loudness. FM broadcasts tend to be companded less than AM ones.
In the UK, at least, TV adverts are transmitted at a higher loudness
than most programme material.
--
David Woolley
"The Elecraft list is a forum for the discussion of topics related to
Elecraft products and more general topics related ham radio"
List Guidelines <http://www.elecraft.com/elecraft_list_guidelines.htm>
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
