I hesitate to reply cuz my experience is so limited. Try this if you haven't already--
Turn on the SUB, turn on B SET, hit the ANT button until Main appears. When my rig came back from Aptos after a sub rx install, it was connected to the Aux antenna instead of the Main. 73, Gary W7TEA Bruce McLaughlin-2 wrote: > > A couple of days ago I received my K-3 back from Elecraft after having the > sub receiver and a few other accessories installed. Unfortunately, the > sub > receiver does not appear to work. I'm sure it's something dumb that I am > overlooking in configuring it. > > Basically, I hear no signals. I do hear what appears to be band noise but > nothing else. This is on 40 meters during the daytime. I have the > configuration set to what I believe is the atu unit. I have only one > antenna which is connected to the main antenna 1 connector. The sub > receiver sounds as though it has no antenna connected to it. The other > choice available on the configuration menu appears to be to connect the > sub > receiver to the BNC connector which appears to be an auxiliary antenna > input > which I do not want to use since nothing is connected there. I have both > the AF and RF gain controls for the sub receiver turned up full. > > Can anyone suggest what I may be doing wrong? I want to use the sub > receiver so that is connected to the same antenna as the main receiver and > transmitter, both of which run through the ATU. I tuned the sub receiver > to > the same frequency as the main receiver which had a very strong sideband > signal and should have been clearly audible by the sub receiver but there > was absolutely nothing other than some background hiss. I will appreciate > any suggestions. > > Bruce-W8FU > > _______________________________________________ > Elecraft mailing list > Post to: [email protected] > You must be a subscriber to post to the list. > Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > > Help: http://mailman.qth.net/subscribers.htm > Elecraft web page: http://www.elecraft.com > > -- View this message in context: http://n2.nabble.com/help-configuring-the-sub-receiver-tp1503368p1503558.html Sent from the Elecraft mailing list archive at Nabble.com. _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
