Ross I assume you are referring to a K3. The "T" means you have CW text
decode turned on. It will not stop you sending CW.
73 Dave, G4AON
K3/100 #80
-------------------------------
I apologise to all for the bandwidth I am taking up, but I have often
found it does help to write things down.
I have just tried SSB I can see the signal on the Winradio and hooking
up the xvtr, I now have output.
The problem may be , under the CW letters on the right hand side of the
screen is a letter T, this is not there if I move to USB.
So what does the T mean, and is it the reason I cannot send CW, if it is
what control removes it?
Again, apologies for the bandwidth but this particular EME project
started in Jan 2008, and is now "almost" completed, and I did want to
check the
1296 mhz 500watt solid state amp which is driven by the transverter, and
see how my 4.5m dish worked on tx.
Regards to all
Ross
ZL1WN
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
