Well spotted Bob. The documentation always takes time to catch up. 73 Stewart G3RXQ On Sun, 16 Nov 2008 10:03:53 -0700, Bob Cunnings wrote: > I don't think it's an error. Inspection of the photographs in the > "Elecraft K3 AF Stage Upgrade Instructions" reveals value code > brown-black-black which is 10mH. The marking on the new part appears > to be 101 which I read as 100mH. > > So it's just a recent change not reflected in the published schematic. > > Bob NW8L > > On Sun, Nov 16, 2008 at 4:19 AM, Stewart Baker > <[EMAIL PROTECTED]> wrote: >> Documentation for the speaker mod says RFC47 is 100uH. However, >> the circuit diagram is marked 10uH. >> >> 73 >> Stewart G3RXQ >> >> _______________________________________________ >> Elecraft mailing list >> Post to: [email protected] >> You must be a subscriber to post to the list. >> Subscriber Info (Addr. Change, sub, unsub etc.): >> http://mailman.qth.net/mailman/listinfo/elecraft >> >> Help: http://mailman.qth.net/subscribers.htm >> Elecraft web page: http://www.elecraft.com >> > _______________________________________________ > Elecraft mailing list > Post to: [email protected] > You must be a subscriber to post to the list. > Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > > Help: http://mailman.qth.net/subscribers.htm > Elecraft web page: http://www.elecraft.com
_______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
