I will ask here before calling Elecraft.
First, I have the following filters installed on the main rcvr, all 8
pole: 6 Khz, 2.8kHz, 1.8 kHz, 400 Hz, 250 Hz.
There are two issues:
1. When I turn my 250 Hz filter on in config, and then select that
filter (which is FL5 here)I can hear noise coming through but no cw
signals come through. I can see the signals on my PowerSDR/LP-PAN
setup and CW Skimmer. Signal comes through all the rest of the
filters O.K. Yes, I opened the radio, and all the filters are installed.
2. I run CW Skimmer with my K3. When I change filters, the CW offset
signal shown on CW Skimmer changes. I thought the 8 pole filters had
no offset. Is anyone else experiencing this? Any comment appreciated.
Dave, W5UN
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
