My K3 is frozen after attempting to load the latest firmware. The red
TX LED is blinking and the display reads "MCU LD" with no back
lighting. No buttons respond, and removing and reapplying power
brings back the same frozen state. I have searched previous emails on
this reflector, and have found no workable solutions. Any ideas?
The K3 communicated OK with the computer prior to attempting the
firmware update.
Dave, W5UN
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
