Dick,
There should already be a felt washer under the VFO B knob (at least,
there is on mine.) To increase the friction, just use an allen wrench
to loosen the two set screws and position the knob a little closer to
the front panel.
73
--
Joe KB8AP
On Nov 25, 2008, at 10:18 PM, Richard S. Lindzen wrote:
I'm personally okay with the front panel design, but I wish the VFO
B knob had a bit more friction. Is there any recommended way of
adding this? Should I just try to cut a felt pad and place it
between the knob and the panel?
Dick Lindzen, KA1SA
301 Lake Avenue
Newton, MA 02461 USA
1-617-332-4342
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
