On Wed, 26 Nov 2008 17:20:48 -0800, Joe KB8AP wrote: > >Has anyone else noticed inappropriate configuration changes after >loading new firmware? > >73
No, not after loading firmware, but changes in band mapping can occur when you stray out of the ham bands. For example: If you have 80/40/30/20 mapped "IN", then go jumping between the 49/31/25 meter SWBC bands(either by direct frequency entry or memory recall), you will subsequently find that BAND UP/DOWN only selects among 80/25/20 meters. What has happened is this: 30m has been transformed into 25m; 40m has been transformed into 49m and mapped "OUT". So, going out of the ham bands is a sure way to jumble up the band scheme. It is easier to recover if you have some anchor freqs for each ham band programmed into the M1-M4 buttons. 73, Drew AF2Z _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
