I am preparing to install an amplifier on my K3. To get the ALC signal from
the 15 pin DIN plug I was hoping to use a VGA cable, cut one end off, and wire
it up accordingly.
Unfortunately pins 3,4,5,6,7,8 and 11 are all grounded in the cable. There are
4 shielded wires in the cable and the ground foil on the outside. So I will
have to cut off the offending pins or spring for a male connector.
Monty K2DLJ
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
