Hello, I am working on the receiver and transmitter alignment at the end of the build process. I used a signal generator to peak up all of the band pass filters and they works as expected. When I try to check the transmit alignment I am not getting to the proper power output. Even peaked up for max smoke I am not getting the proper power out. 3.750mhz 2.5w Hi Cur 7.100mhz 6.1w Hi Cur 10.100mhz 0.3w Hi Cur 14.100mhz 0.3w Hi Cur 18.100mhz 9.5w 21.100mhz 4.1w 24.900mhz 0.5w 28.200mhz 6.0w All of these were tested with a external wattmeter & the internal meter. I also validated that dummy load not the issue by testing this using a triband antenna on 20m and the measurements matched. Do you have any suggests on some places to look? It is possible that it could be an issue with the low pass filters but I find it hard to believe that I messed up all five filters. You would think that at least one of them would be ok. :-) Thoughts? Please respond direct as well as to the list... I get the digest version so it could be a while before I see next digest email. Thanks, JH ----------------------------- John Hoaglun NG0R - EN25 http://www.hoaglun.com
_______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
