Heh, that's funny, I just requested the same thing... However, you can get several scan rates by using FINE, COARSE or RATE. These give you aprox 150 Hz/sec, 1.5 KHz/sec and several kHz/sec, if I recall.
I wouldn't mind having an intermediate rate between the two slowest ones. One seems too slow and the other too fast. I don't use the fastest one at all. I also would like to have a fixed selectable dwell time on the muted scan. Sometimes it pauses for a couple of seconds, sometimes for a lot longer. I would just like to have it pause for, say, 5 seconds every time it stops. I use scanning on the CW bands, usually in unmuted mode with a very wide filter. It's nice to be able to scan the bands while you're busy with other stuff in the shack. A tap of the key stops the scan. 73, Drew AF2Z On Fri, 05 Dec 2008 12:00:58 -0800, Bob N6WG wrote: >Is there any adjustment somewhere to slow down the scan rate? >Mine goes too fast, and by the time I hear a station the K3 has >shot past it, and it's hard to get back to the station's frequency. > >Any info? > >Thanks and 73 >Bob N6WG _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
