Have you enabled the 2.7 kHz filter for all modes in receive using the CONFIG FLx menu or the K3 Utility's Crystal Filter Configuration page?
Dick, K6KR From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of Howard K2HK Sent: Sunday, December 07, 2008 7:33 AM To: [email protected] Subject: [Elecraft] Update and another request Lost SSB after KRX3 install..Ideas? After sending the msg below I removed the KRX3 and also reinstalled the 2.7 filter whose position had been moved on the RF board. Neither of these made any difference. KRX3 works as expected, CW works as usual but......no audio output on SSB. Howard..K2HK HK No TX audioDate: Sat, 6 Dec 2008 18:12:28 +0000 I recently installed the KRX3 in my K3. At the same time I moved some filters and installed an additional one on the main board . I now have the problem of no audio on SSB. Works FB on CW. I am thinking the culprit is likely to be the 2.7KC filter on the main board. Before opening up things again I thought I would ask for some suggestions.Howard..K2HK HK
_______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
