Carsten - I am experiencing the same problem. At this point, after confirming that it's not the KAIO3 boards, Elecraft suspects a bad DSP board, and they're sending me a replacement. I'm hoping this resolves the problem.
Good luck & 73, Steve NN4X On Tue, Dec 9, 2008 at 5:34 AM, Carsten Steinhöfel < [EMAIL PROTECTED]> wrote: > > Hi there, > > I have a little problem with K3 #549. I do not get AF out of the internal > Speaker > or rear-panel Speaker output. I am usually using headphones so only noticed > it > recently in Senegal when I wanted to have my YL listen to a sked with home. > > It doesn't seem to be a hardware problem because when I set SPKR+PH to yes > in the > menu I do get output. Only if it is set to no and I don't have headphones > connected > is there no output. I've tried setting SPKRS to 1 and 2 with no difference. > Is > there some other setting that I am missing that could be causing this > behaviour? > > I've also tried upgrading to the latest firmware but that didn't make a > difference > either. > > I'd be grateful for any ideas. > > Thanks and regards, > > Carsten, DL1EFD > > _______________________________________________ > Elecraft mailing list > Post to: [email protected] > You must be a subscriber to post to the list. > Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > > Help: http://mailman.qth.net/subscribers.htm > Elecraft web page: http://www.elecraft.com >
_______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
