nl7g wrote:
>
> I am on the waiting list for a K3 and have ordered the KXR3.
> In reading the manual for both the Sub Receiver and the K3
> an alarm bell starting ringing in my ears when I read.
> Not Quoted: Basically saying
> 1. A 3db splitter is used when the KXR3 is installed. Turn off
> the Sub Receiver and the Main RX sensitivity is restored
> to normal.
> 2. Also stating this 3db splitter (effectively a pad??) is in use
> for both antenna ports, but is not used when the RX only
> antenna port is used.
>
> In audio terms isnt 3db half of the power?? How much
> sensitivity is compromised by installing the 2nd receiver to
> the main receiver?
>
> I am trying to work some of you guys in the noise floor.
> Do I need to turn off the sub receiver every time I am
> trying to work a barely audible station??
> IF this is a real problem, I have time to cancel my KXR3.
> Any practical experience by those who have received
> their sub receiver would be greatly appreciated.
>
> Thanks Mike NL7G
>
3 dB should not be a major a problem except possibly on 10/6m, where you
might need a preamp. The atmospheric noise floor on the lower bands is well
above the noise floor of the K3 and you'll probably not miss 3 dB. For
example on 160m I normally operate with the 10 dB ATTenuator on. On 10m my
"preamp" is a 22 dBi gain antenna so I doubt 3 dB is an issue for me (no
sunspots is an issue however!)
73, Bill
--
View this message in context:
http://n2.nabble.com/KXR3-3db-Splitter-tp1647375p1647409.html
Sent from the [K3] mailing list archive at Nabble.com.
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
