Hello My K2 is in the phase of alignment and Test, Part III. In the transmitter alignment with 2, 5 or 10 watts I have the voltage and current similar to the manual (10 watts 11.5v and 1.98 amp). Test Setup: 100w dummy and WM-2 Wattmeter from oak hills Everything seems OK. Power and current remain stable during the tuning time (5-10 sec). But then I have realized that I have differences in the reading of the power level before and after I push the TUNE Button. E.g.: Power Set: 5 Watt then TUNE and the Display shows 7.1 Watt! Problem: If I repeat this procedure 10 times I read different, but stable values between 4.8 and 7.1 Watt. The Wattmeter shows the same values as the display.
I think there is something wrong, but I didn't found this behavior in the troubleshooting section. Can you help me? Many thanks Edi, HB9BQJ
_______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
