My K3 is #1025. I think I am on version 2.67. I do dot observe the audio reduction. If I have a pop, it is high frequency because I do not hear it. My hearing is such that I don't hear above about 2.7 kHz. It is the same for both receivers. It is the same pre-amp on and off. The test was made at 7052 Khz.
Willis 'Cookie' Cooke K5EWJ --- On Tue, 12/23/08, [email protected] <[email protected]> wrote: > From: [email protected] <[email protected]> > Subject: [Elecraft] 50 and 100 DSP positions > To: [email protected] > Date: Tuesday, December 23, 2008, 9:24 AM > Hi all, > > On K3's #94 and #965, on cw when you narrow the DSP > down past 150 to 100, there is a noticable pop in the > speaker and the audio becomes quite muted. The S meter still > shows the same strength. Both are running 2.73. I've > tried moving the IF shift but still muted audio. You can > hear it, but just way down. > > Can anyone verify if their's acts the same way? > > thanks!! > > Terry > _______________________________________________ > Elecraft mailing list > Post to: [email protected] > You must be a subscriber to post to the list. > Subscriber Info (Addr. Change, sub, unsub etc.): > http://mailman.qth.net/mailman/listinfo/elecraft > > Help: http://mailman.qth.net/subscribers.htm > Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
