Hmmm. I do have a 6Khz filter installed. This is NOT happening on my
radio (2.76, #2091). If I configure the 6khz filter out, it still
does not occur.
Grant/NQ5T
On Dec 25, 2008, at 10:03 PM, John Buck wrote:
I confirmed on K3 #125 with V 2.76, the behavior described by KB8AP
below.
I also noted that the power supply jumps up to the level expected
for the power setting.
So I believe that it is attempting to transmit during the second or
so of the transient.
This is not a good thing. I do not have a 6 kHz filter installed.
John KH7T
Hi all,
I've just discovered something odd with my K3 (#1772). When I
switch mode from DATA to AM via the front panel Mode button, the rig
tries to transmit. The red TX light comes on momentarily and I get
a ERR TXF message (if in band) or an END message (if out of band) in
the VFO B area. I don't have the AM filter installed, so I don't
think anything is actually going out over the air, but it doesn't
seem like the rig should ever go into transmit on a mere mode change.
It ONLY happens when going from DATA to AM, not when going from FM
to AM or between any other modes in either direction. There is no
mic connected to the rig, nor anything connected to the rear panel
mic or line inputs. The only things connected to the rig are a
paddle, an external speaker, and the antenna. It happens whether
in VOX or PTT mode.
I first noticed it with MCU 2.67 (although I can't say if it
happened with earlier versions.) I've updated to the 2.76 beta
release and it still happens.
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
