I was putting together a kit this evening (non Elecraft) and discovered I was
using the wrong instruction sheet version to the parts and board I was using.
(Always check your parts before beginning - which I did not) I had to putt
about 10 resistors of the board. They are plated through holes. I did not
have a vacuum desoldering station...so I have to think of somethingto get the
solder out of the holes. A small drill? Anyone has some comments?
Lee Buller - K0WA
"Embarrased to say the least"
In our day and age it seems that Common Sense is in short supply. If you don't
have any Common Sense - get some Common Sense and use it. If you can't find
any Common Sense, ask for help from somebody who has some Common Sense. Is
Common Sense divine?
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
