Simon (HB9DRV) wrote:
>
> Look at the IF command - saves a few steps.
>
>
The IF command only gives the RX frequency. It will tell you if you are
working split or have XIT on as well, so I suppose it saves a few commands,
but as it sends a lot of other info you don't need it's arguable what you
are saving. You could send FT;FA;FB; as one string and then sort the results
out afterwards.
-----
Julian, G4ILO. K2 #392 K3 #222.
http://www.g4ilo.com/ G4ILO's Shack http://www.ham-directory.com/ Ham
Directory http://www.g4ilo.com/kcomm.html KComm for Elecraft K2 and K3
--
View this message in context:
http://n2.nabble.com/K3%3A-How-to-determine-TX-Frequency-Over-Serial-Port-tp2114913p2117017.html
Sent from the Elecraft mailing list archive at Nabble.com.
_______________________________________________
Elecraft mailing list
Post to: [email protected]
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
http://mailman.qth.net/mailman/listinfo/elecraft
Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com
