Phil, Since this is primarily a check for shorts on the paddle input lines, I do not think you should be concerned - continue building.
73, Don W3FPR Phillip Heller wrote: > Everything checks out per the Control Board resistance checks, though > U6 29 & 30 to Ground show 95-97k ohm (dependent upon dmm polarity). > > So that's 5-7kohm greater than the range shown in the table, but less > than 10% deviation... > > Is this something I should concern myself with? > > --phil > > _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
