YES, Ian, YES!
I support your idea and when thinking of it....another one about the Notch controls. The situation now is, that when the manual notch is switched on, and the notch freq is on the VFO B display, I cannot move the VFO A!! I first have to tap the DISP button or the Notch again. In case of touching either button, the manual notch stays on. How about this solution: Tap Notch: auto notch comes up Tap again: auto notch switches off. Hold Notch: manual notch comes on , as it is now, and notch freq visible in VFO B display, and you are able to move VFO A Tap Notch again: Notch switches off and VFO B display goes back to normal If you want the normal VFO B display again and manual notch stays on, tap DISP AND: So VFO A is always unlocked during this. 73 Arie PA3A -----Oorspronkelijk bericht----- Van: [email protected] [mailto:[email protected]] Namens Iain MacDonnell - N6ML Verzonden: woensdag 7 januari 2009 22:37 Aan: Elecraft Onderwerp: [Elecraft] Notch control A minor "usability" issue... Tapping NOTCH once engages "auto" mode, then a second tap goes to "manual", then a third tap turns notch off. That's all OK... except when I tap once to "auto", then, a short while later, the lid who was throwing a carrier goes away, I tap the button again, and expect it to turn notch off, but it still cycles into manual mode, requiring a further tap. Sooo... perhaps if auto mode has been engaged for more than a second or so, a single tap could turn notch off, instead going to manual mode? Actually, thinking about it some more; maybe manual mode should only come into play on "hold" instead of "tap"? I imagine other would have different preferences, though.... Comments? ~Iain / N6ML _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com _______________________________________________ Elecraft mailing list Post to: [email protected] You must be a subscriber to post to the list. Subscriber Info (Addr. Change, sub, unsub etc.): http://mailman.qth.net/mailman/listinfo/elecraft Help: http://mailman.qth.net/subscribers.htm Elecraft web page: http://www.elecraft.com
